Description

FT-MTRS-1E31-01   is   a   high   performance,   cost effective modules, which is supporting Multi Rate4.9152Gbps to 10.3125Gbps, and transmission distance up to 10km on SM fiber. The transceiver consists of two sections: The transmitter section incorporates a laser driver and a 1310nm DFB laser. The receiver section consists of a PIN photodiode integrated with a transimpedance preamplifier (TIA) and a Limitting Amplifier. The module is hot pluggable into   the   20-pin   connector.   The   high-speed electrical interface is base on low voltage logic, with nominal 100 Ohms differential impedance and AC coupled in the module.

The optical  output can be disabled  byLVTTL logichigh-levelinputofTX_DIS.TransmitFault (Tx_Fault)isprovidedtoindicatethatthemodule transmitterhasdetectedafaultconditionrelatedto laseroperationorsafety.Lossofsignal(RX_LOS) outputisprovidedtoindicatethelossofaninput opticalsignalofreceiver.AserialEEPROMinthe transceiverallowstheusertoaccesstransceiver monitoringandconfigurationdataviathe2-wire SFPManagementInterface.Thisinterfaceusesa singleaddress,A0h,withamemorymapdivided into  a  lower  and  upper  area.  Basic  digital diagnostic(DD)dataisheldinthelowerarea while specificdataisheldinaseriesoftablesinthehigh memoryarea.

Features

●  Upto10kmtransmission distance

●  Support MultiRate 4.9152 Gbps to 10.3125 Gbps

●  1310nm DFB Laser Transmitter and PIN Receiver

●  SFIelectrical interface

●  2-wire interface for integratedDigital Diagnostic monitoring

●  SFP+MSApackagewith duplexLC connector

●  Hot pluggable

●  VerylowEMI and excellent ESD protection

●  +3.3V power supply

●  Power consumption less than1.0W

●  Operating casetemperature: -40~+85°C

Applications

●  High-speed storage area networks

●  Computer clustercross-connect

●  Custom high-speed data pipes

●  LTE optical repeater application

Compliance

●  CompliantwithFiber Channel(FC)-Standard INCITS352

●  CompliantwithIEEE 802.3ae-2002

●  Compliantwith SFF-8431

Specification

Notes:

[1]  Non-condensing state

Notes:

 [1]Eye Mask Margin(1000 consecutive snapshots at typical rate and room temperature)

Notes:

 [1]Time from rising edge ofTXDisable towhen theoptical output fallsbelow10% of nominal

 [2] Time from falling edge of TX Disable to when the modulated optical output rises above 90% of nominal

 [3] From power on or negation of TX Fault using TX Disable

 [4] Time from fault to TX fault on

 [5] Time TX Disable must be held high to reset TX_fault

 [6] Time from LOS state to RX LOS assert

 [7] Time from non-LOS state to RX LOS deassert.

Important Notice

Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice.

The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.